18
5 PCB settings
5-1 PCB start-up check (self test)
When the power switch is turned ON after installation of machine, the performance
of game Printed Circuit Boards (PCB) is checked automatically and the result is
displayed on the screen.
•Be sure to perform the self test before using the machine.
•If an abnormality persists or the machine does not operate properly,
immediately turn OFF the power switch, unplug the power cord from the
receptacle and contact your nearest dealer.
Result of test
·The machine goes to the game mode and the demonstration game gets started.
If test is OK
· “ BAD ” appears on the screen, and the checking is repeated.
If “24G BAD” is displayed, once turn OFF the power switch and then turn it ON
again while depressing the test switch button on the service panel. (The content
of setting in manual test return to those having been set at the time of shipment.)
After the installation of the machine, or after the repair or replacement of PCB,
turn ON the power switch while pressing the test switch on the service panel and
once return the settings to the factory settings.
If an abnormal display continues or the machine does not operate normally,
immediately turn OFF the power switch and contact your nearest dealer.
If any abnormality is detected
