GB
IE
30
WK 5 A1
Activating live mode
Live mode is the standard operating mode of the camera. In this
mode, recordings are triggered via the motion sensors
6
,
7
. To set
live mode, slide the operating mode selector switch
18
to the "ON"
position. After fifteen seconds the red LED of the standby indicator
2
will go off. Then the camera will start to operate independently and
will go into standby mode. As soon as any wild or other animals or
people enter the detection range of the central sensor zone, the
camera will start capturing photos and/or videos (depending on
the configuration).
If wild animals enter the detection range of the side motion sensors
7
, these will detect the motion and activate the camera. If the wild
animals continue to move in front of the front motion sensor
6
, the
camera will continue taking photos/videos. When the wild animals
leave the detection range of the side motion sensors
7
, the camera
switches off and goes back into standby mode.
Night exposures
During night exposures the infrared LEDs
1
on the front of the camera
provide the required light for making recordings possible. The LEDs
emit light over a wide angle. This makes it possible to make night
recordings at a distance of about 3 m to 20 m without overexpos-
ing the subject. However, reflective objects such as traffic signs can
cause overexposure if they are located within the recording range.
Please note that night exposures are made in black and white.
