- 22 -
2. Place the charging station
7
next to a power
socket and plug the power adapter in.
The charging station can optionally be moun-
ted on a wall with the supplied screws and
plugs
i
(see Chapter „Mounting the wall
bracket“). Vertical screw spacing 102 mm,
screw diameter 3,5 mm. The borehole has to
fit for plug diameter 5 mm.
You can store the crevice tool
and the
upholstery brush
in the slots on the charging
station
7
.
3. Place the hand vacuum cleaner in the charging
station
7
.The charge indicator light
6
lights up
red and the charging process begins.
Important:
• Once the charging process is completed, the
appliance automatically switches to the charge
maintenance function. However, in order to avo-
id possible damage to the batteries, do not lea-
ve the appliance constantly connected to the
charging station .
• Only place the appliance back on the charging
station
u
once the vacuum power becomes
noticeably weaker.
Important information about the
battery
In the event of a defective battery, please contact
our service centre directly. Please refer to the gua-
rantee card for the Authorized Service Outlet in
your country.
Mounting the Wall Bracket
1. Bore two holes with a spacing of ca. 102 mm.
Using the wall bracket
7
to mark the boreholes
ensures the correct spacing.
2. Push the plugs
8
into the boreholes and screw
in the lower screw
8
until ca. 3mm is
protruding.
3. Place the wall bracket
7
on the lower screw.
4. Guide the upper screw
8
through the wall brak-
ket
7
and into the borehole, then screw it in.
5. Tighten both screws
8
down.
Assembly
NOTE:
Make certain that the dust filter
3
is always inser-
ted before using the appliance.
1. To open the dust collector
2
, turn the dust
collector
2
and pull it off the motor unit
4
.
Make certain that the dust filter
3
is inserted
and put the dust collector
2
back on. Turn the
dust collector
2
until the arrow symbol points to
the dot
on the motor unit
4
.
2. Should the crevice tool
or the upholstery
brush
be required, insert them into the
suction opening of the dust collector
2
.
Operation
1. Remove the hand vacuum cleaner from the char-
ging station
7
. Using the supplied plugs and
screws
8
the charging station
7
can optionally
be mounted on the wall.
2. To switch the appliance on, move the on/off
switch
5
to the position "I".
3. After use place the on/off switch
5
into
position “O“.
4. The crevice tool
is used to clean narrow,
hard-to-reach areas.
IB_KH4421_E30172_LB5 02.02.2009 16:59 Uhr Seite 22
