Kompernass KH 3300, Руководство по эксплуатации и технике безопасности

Страница: 20 / 68

• The wire must be fully wound out
• Determine the best position by trial and error
• Attach the wire aerial to the wall if necessary using a strip of adhesive tape.
For MW reception, place the device in the best position for the in-built aerial, again by trial and error.
OPERATING THE RADIO/ SELECT BAND (FM/MW)
0 1) Select TUNER (=Radio) using the device selector (19) button.
0 2) Select between FM and MW by pressing the wave band selector button (19) again.
AUTOMATIC STATION SEARCH / MANUAL SEARCH
In an automatic search the frequency is increased or deceased until a station of adequate reception strength is found.
0 1) Hold down the Forward button (8) or Reverse button (12) for about 1 second – the search starts and stops automatically.
0 2) To start the search again, hold down the Forward button (8) or the Reverse button (12) again for about 1 second.
You can use the manual station search for fine adjustment or when the frequency of the station is known.
0 1) Press the Forward button (8) or the Reverse button (12) briefly to increase or decrease the frequency in small steps.
0 2) Keep the Forward button (8) or the Reverse button (12) pressed until you are close to the frequency you require.
STORE STATION [ " MEMORY " ]
The Designer Audio Unit KH 3300 can store up to 40 stations (20 FM / 20 MW).
0 1) You set up the desired station by following the instructions relating to "Automatic station search/manual station search" described above.
0 2) Press the MEMORY/CLK-ADJ button (9) once. Next the station number shows for 5 seconds on the left side of the display (15).
You must carry out the next step within these five seconds, otherwise the device switches itself into normal display.
If this happens, press the MEMORY/CLK-ADJ button (9) again.
0 3) Press the M-UP/REPEAT button (7) repeatedly until the required station number (1 to 20) is displayed.
Repeat this procedure for all the other stations you require have been stored.
SELECT STORED STATION
In radio mode, press the M-UP/REPEAT button (7) repeatedly until the required station number for the stored station is shown in the display (15).
17
16
15
14
19