e) Any cleaning agent used on the heater should be of a non-combustible and
non-corrosive nature.
f) The stainless steel emitter grid normally does not require cleaning and should
NEVER be painted. The reflector may be cleaned, but never painted.
7. The hose assembly should be properly located out of pathways where people
may trip over it. The hose must be protected from contact with hot or sharp
surfaces both during use and while in storage. The hose assembly should be
visually inspected prior to each use of the heater. If excessive abrasion or wear is
evident, or the hose is cut, it must be replaced prior to operating the heater.
8. DO NOT use any pressure regulator or hose assembly other than those supplied
with the appliance.
9. This heater is designed to operate with a standard 9kg propane gas cylinders
with an Approved Cylinder Connection.
10. The valve outlet must be maintained in good working condition. When the
cylinder is not in use, be sure to cover it with a dust cap. A leak test should be
performed with soapy water whenever you connect a new cylinder. NEVER use a
match to test for leaks.
11. The propane gas cylinder must be turned off whenever the heater is not in use.
When the heater is to be stored indoors, the propane gas cylinder must be
disconnected and stored in accordance with the Standard for Handling of
Liquefied Gases. (not indoors, but in a dry, well ventilated area).
12. The patio heater has been designed with several safety features including a tip
over switch.
NOTE: The plastic container in the base must be filled with sand prior to use.
•
Do not shorten the post length.
•
Do not bypass the thermocouple safety
•
Do not operate the heater without the reflector
Clothing or other flammable materials should not be hung from the heater or placed
near the heater. The area above the post may become extremely hot.
Cylinder Connection Device
Model:
KDGASPATHTRA (PH07-S)
Gas Consumption:
40MJ/h
Pressure KPA:
2.75kpa
Injector Orifice:
1.85mm
Gas Type
Propane
IAPMO
GMK10261
4