8
© 2021 Kolpin Outdoors Inc.
REV 00
TALON 1000 WINCH INSTALLATION (continued):
9.
Install the Frame Clamps (item #5) onto the back side of
the vertical frame tubes, lining up with winch mount plate
(item #1) as shown. Fasten the clamps by inserting M8
screws (item #8), M8 lock washers (item #6) and M8 flat
washers (item #7) through the winch mount plate holes.
(See illustrations 1
-
10, 1
-
11 and 1
-
12).
Note, do not
tighten hardware at this time.
10.
Tighten the OEM bumper hardware to specifications
listed below: four M8 upper bumper screws, two M8 lower
bumper screws, two M6 upper plastic grille screws and
two M5 lower plastic grille screws.
11.
Tighten the Winch Mount M10 and M8 hardware
as specified below. (See illustration 1
-
13).
Ill. 1
-
11
Front
Gear
Case
Ill. 1
-
12
5
FRONT
8
6
PLASTIC GRILLE 6MM FASTENER TORQUE:
7 ft. lbs. (9.5 Nm)
7
5
PLASTIC GRILLE 5MM FASTENER TORQUE:
4 ft. lbs. (5.5 Nm)
BUMPER 8MM FASTENER TORQUE:
17 ft. lbs. (23 Nm)
Ill. 1
-
13
3
4
8
6
7
10MM FASTENER TORQUE:
34 ft. lbs. (46 Nm)
8MM FASTENER TORQUE:
17 ft. lbs. (23 Nm)
