Kollmorgen SERVOSTAR 640, Инструкция по эксплуатации

Страница: 60 / 118

8.12.4 Connection to a SSI encoder (X5)
You can set up the SERVOSTAR 640/670 as a slave following a synchronous serial absolute-enco-
der (master-slave operation). This application uses the SubD connector X5.
If lead lengths of more than 50 m are planned and for questions concerning the power supply of the
encoder, please consult our customer service.
Frequency limit: 1.5MHz
AGND and DGND (connector X3) must be joined together!
8.12.5 Connection to stepper-motor controllers (step and direction)
This interface can be used to connect the servo amplifier to a third-party stepper-motor controller.
The parameters for the servo amplifier are set up with the aid of the setup software (electrical gea-
ring). The number of steps can be adjusted, so that the servo amplifier can be adjusted to the
pulse-direction signals of any stepper-motor controller. Various monitoring signals can be output.
Observe the frequency limit!
Using an A quad B encoder provides better EMC noise immunity.
Speed profile and signal diagram
60 SERVOSTAR
®
640/670 Instructions Manual
Electrical Installation
12/2010
Kollmorgen
SERVOSTAR 640/670