AKI2G-CDB-MOD-12T-000 | SAFETY PRECAUTIONS
Terminal Block Connector
Wire Size AWG
TQ Lb.In.
X1/X100 Phoenix connectors
AWG 30–12
5–7
X1/X100 Anytek connectors
AWG 24–12
3.5
X1/X100 DECA connectors
AWG 24–12
7
•
These devices are Class 2 supplied programmable controllers (industrial PCs) for the use in
industrial control equipment and are intended to be (front) panel mounted (Type 12 and 4x for
indoor use only).
Caution:
The enclosure provides a degree of protection of at least IP20, but when installed in an
apparatus, it should meet IP65..
LE BOÎTIER OFFRE UN DEGRÉ DE PROTECTION D'AU MOINS IP20, MAIS
LORSQU'IL EST INSTALLÉ DANS UN APPAREIL, IL DOIT ÊTRE DE CLASSE IP65..
2.4
During Installation
•
The HMI panel is designed for stationary installation on a planar surface, where the following
conditions are fulfilled:
–
no high explosive risks
–
no strong magnetic fields
–
no direct sunlight
–
no large, sudden temperature changes
•
Install the HMI panel according to the accompanying installation instructions.
•
Ground the HMI panel according to the accompanying installation instructions.
•
Only qualified personnel may install the HMI panel.
•
Separate the high voltage, signal, and supply cables.
•
Make sure that the voltage and polarity of the power source is correct before connecting the HMI
panel to the power outlet.
•
Peripheral equipment must be appropriate for the application and location.
2.5
During Use
•
Keep the HMI panel clean.
•
Emergency stop and other safety functions may not be controlled from the HMI panel.
•
Do not use excessive force or sharp objects when operating the touch screen.
2.6
Service and Maintenance
•
Only qualified personnel should carry out repairs.
•
The agreed warranty applies.
•
Before carrying out any cleaning or maintenance operations, disconnect the equipment from
the electrical supply.
•
Clean the display and surrounding front cover with a soft cloth and mild detergent.
ky
Kollmorgen | April 2017
7
