Innovative Network RTK Receiver
NtripClient
This is the general used function for rover set in WIFI mode. At the field of NtripClient, the specify IP address,
access port of reference station, as well as the assigned username and password shall be input for the NTRIP
connection.
Status:
This field will display the status of NTRIP connection, connect or disconnect.
Active:
Check on this circle to activate this function.
Authentication Mode:
These three modes use different protocol standard for the connection,
Eagle Mode
is
KOLIDA standard mode, and
TCP/IP Mode
is for private network use, usually, choose the Eagle mode for the
default setting.
LARK Mode
is a totally new communication mode for network connection, it is similar to the CSD
function that establishes connection between Base and Rover via GPRS network type, rather than GSM. However,
S680N is without the GPRS module inside, this function is not supported on S680N receiver.
The next fields are the standard configuration for NTRIP connection, IP, port, username and password, after these
information is input into the corresponding field, click on Get Point button to download the source table from
server, then choose a proper mountpoint to access.
