11
Telescopic pole assembly
Note: a V-clip is installed inside the pole connector to secure the telescopic pole (not
included) in position. Slide the telescopic pole onto the pole connector. Press on the
side pins of the connector and slide the telescopic pole further down until the pins of
the connector are secured inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out
the pole.
Suction head assembly
Insert the suction head directly into the suction mouth of the pool vacuum until the
side tabs of the transparent case clip in the holes of the suction head’s pivot.
NOTE: To replace the brushes on the suction head, lift one end and pull the brush out
to make space for a new one.
WARNING!
For vinyl liner and fibreglass pools, it is recommended to keep the
brushes on the suction head to avoid damaging the pool.
OPERATION
WARNING!
Do not use the pool vacuum if any damage is detected.
Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
Do not operate this pool vacuum if there are people/pets present in the water.
