-6-
(7) When mounting Tail Cover (A)
[47]<47>
and Tail Cover (B)
[44]<44>
, check the position of the Cord
[45]<45>
, pigtail of the Carbon Brush (1 Pair)
[40]<40>[48]<48>
, and internal wires of the Noise
Suppressor
[38]<38>
as shown in Fig. 9.
NOTE: • Be careful not to sandwich the Cord [45]<45> and the internal wires of the Noise
Suppressor [38]<38> between Tail Cover (A) [47]<47> and Tail Cover (B) [44]<44>. Fit
the Cord [45]<45> in the groove of the Housing [36]<36>.
• Be careful not to put the pigtail of the Carbon Brush (1 Pair) [40]<40>[48]<48> on the
top of the Brush Holders [42]<42> when mounting Tail Cover (A) [47]<47> and Tail
Cover (B) [44]<44>. Before mounting Tail Cover (A) [47]<47> and Tail Cover (B) [44]<44>,
check the pigtail position.
• Mount the Ferrite Core [57]<57> as shown in Fig. 10.
(8) Tighten three of the four Seal Lock Screws (W/Sp. Washer) M4 x 14
[7]<7>
except the one for securing
the Lever Holder
[8]<8>
. Mount the Lever
[27]<27>
and Retaining Ring D4
[28]<28>
to the Lever Holder
[8]<8>
. Hook the Spring
[26]<26>
on the Lever
[27]<27>
. Then tighten the remaining Seal Lock Screw
(W/Sp. Washer) M4 x 14
[7]<7>
.
Fig. 9
Proper
Improper
Check that the pigtail is not put on the Brush
Holder
[42]<42>
before mounting Tail Cover
(A)
[47]<47>
and Tail Cover (B)
[44]<44>
.
z
Do not sandwich the Cord
[45]<45>
and the
internal wires of the Noise Suppressor
[38]<38>
between Tail Cover (A)
[47]<47>
and Tail Cover (B)
[44]<44>
.
Fig. 10
Wind the Cord
[45]<45>
two
turns around the Ferrite Core
[57]<57>
.
