1435817-2-B
2
How to Connect the Hoses
□
Connect and tighten the check valve housings(9) to
water supplies. Connect and tighten the supply hoses
(10) to the check valve housings. The supply hose with
“COLD” label should be connected to cold water.
Another hose should be connected to hot water.
□
Open hot and cold water supplies. Turn on the faucet.
Flush hot and cold water for about one minute to remove
any debris. Shut off the faucet and water supplies.
NOTE:
Supply hoses must not be taut, kinked, or twisted
during installation. If the supply hoses must be coiled,
maintain an inside diameter of minimum Ø76mm.
12
13
15
11
2
16
14
Ø76mm Min.
9
10
11
1
3
4
5
6
7
2
8
How to Install the Faucet
□
Slide the base(1, foam side down) over the hoses,
wire(2) and shank(4) until it contacts the faucet bottom.
□
Insert the faucet assembly into the mounting hole from
upside of the sink with the handle on the right.
□
Partially thread the screws(5) into the screw holes of
the threaded ring(6).
□
From underside of the sink, slide the rubber washer(7),
washer(8) and threaded ring(6) over the hoses, wire(2)
and shank(3). Thread the threaded ring onto the shank
until the washers contact the underside of the sink. Make
sure the faucet is positioned correctly.
□
Tighten the screws(5).
INSTALLATION
How to Install the Valve Box
IMPORTANT! Risk of restricted waterflow.
The spray
hose(12) must not be taut or kinked when installed.
□
Handtighten the valve box outlet fitting(13) onto the
valve box(14).
□
Push the spray hose(12) connector onto the valve box
outlet fitting until a click is heard.
□
Push the valve box inlet fitting(15) onto the outlet hose
(11) until a click is heard.
□
Connect the sensor wire(2) to the wire(16) on the valve
box. Align the arrows on both connectors and push
together. Tighten the nut to secure the connection.
