1435817-2-B
3
How to Install the Spray Hose Weight
NOTE:
Make sure the spray hose weight(28) will not
interfere with the valve box or wire connections.
□
Adjust the weight to the appropriate position and
squeeze to connect the clasp.
□
Extend and retract the spray hose to check for smooth
operation.
28
□
Ensure that all connections are tight.
□
Ensure that the handle is in the off position.
□
Turn on the main water supplies and drain.
□
Check all connections for leaks. Repair as needed.
INSTALLATION CHECKOUT
Valve Box
Supply Hose
Spray Hose Weight
Spray Hose
Battery Box Wire
Battery Box
Outlet Hose
Supply Stop
Check Valve Housing
How to Install the Battery Box
NOTE:
Before selecting a location for the battery box,
verify that the battery box wire(17) will reach the power
wire(18) on the valve box.
□
According to the actual conditions, select one of the
installation ways as follows.
Way 1: Screw and anchor
1) Select a suitable location on the wall and drill a hole as
the anchor(19) diameter.
2) Press the anchor into the hole, and then screw the
screw(20) into the anchor.
Way 2: 3M double sided tape and hook (Only apply for
flat and smooth walls.)
1) Clean the hook(21) backside and installed location of
the wall. Be sure to remove oil, water and dust.
2) After the surface is dry, tear off one paper of the 3M
double sided tape(22), stick it on the hook backside, and
press it evenly for a while after bonding.
3) Tear off another paper of the 3M double sided tape.
Ensure the hook is horizontal and in the right place, and
then paste it onto the wall and press it firmly.
□
Press the tab(23) on the battery cover(24) to remove.
Insert six AA batteries(25) into the battery holder(26).
Reinstall the battery cover on the battery holder.
□
Hang the battery box(27) on the screw(20) or hook(21).
Connect the battery box wire(17) to the power wire(18) on
the valve box.
26
24
25
23
19 20
22
21
Way 1
Way 2
18
27
17
