Kohler STERLING 7610 Series, Руководство по установке

Страница: 8 / 64

4. Prepare the Whirlpool
Remove the Apron Access Panel
Insert a flat-blade screwdriver or other prying tool into one of the screwdriver slots.
Use the screwdriver to pry the bottom clip out and release the clip.
Repeat this procedure at the remaining screwdriver slots.
When all bottom clips are released, pull the bottom of the panel away from the apron to release the
remaining clips.
When the bottom of the panel is clear, lower the panel until the top of the panel is clear.
Store the panel in a safe place.
Prepare the Whirlpool
Place a clean drop cloth or similar material in the bottom of the whirlpool.
Install the whirlpool drain and overflow to the unit according to the drain manufacturer’s
instructions. Do not connect the trap at this time.
If the subfloor is not constructed of plywood, position the provided felt pad so the whirlpool
supports will rest on it.
IMPORTANT! Risk of product damage. Do not lift the whirlpool by the apron or apron braces, or by the
piping or pump. Do not use the piping or pump for structural support of the whirlpool.
IMPORTANT! Ensure that each apron brace is connected at all bosses.
IMPORTANT! Use care to properly position the whirlpool in the alcove, as proper placement is critical for
attachment to the studs. Clear all material away from the pump support bracket area and the whirlpool
supports. The pump support bracket and the whirlpool supports must rest directly on the subfloor.
Carefully lift the whirlpool into place.
Make sure the pump support bracket and whirlpool supports do not rest in the bed material.
Verify that the whirlpool is properly positioned with respect to the intended finished wall.
Depending on the installation, the outer edge of the whirlpool should be flush with the intended
finished wall at floor level.
Verify that the whirlpool is level and resting on all supports. The whirlpool should be within 1/8
″
(3 mm) of level from side to side, and within 1/4
″
(6 mm) of level lengthwise. If the whirlpool is
not level, remove the whirlpool and place shims under the supports.
Clip
Nine Clip Locations
Four Screwdriver Locations
Apron Panel
Center Clip
Apron Frame
1016902-2-F 8 Sterling