3. Install the Wall Jambs and Optional Filler Jamb
With a pencil, mark the location of the wall jamb on the shower wall. Measure evenly on both sides.
Place the wall jamb against the wall and check for plumb with a level. The adjustment clamps will
be located closer to the inside of the shower.
Make a pencil mark at each of the four pre-drilled holes in the wall jamb and remove the wall jamb.
Lightly center punch the four hole locations on each wall.
When the installation is on ceramic tile, use the center punch to nick the surface glaze. Tap the
punch lightly with the hammer to avoid cracking the ceramic tile.
Drill each hole with a 5/16
″
drill bit (use a masonry bit for ceramic tile).
Press and hold the legs of each wall anchor (provided) together and insert the wall anchor legs into
the pre-drilled mounting holes.
Repeat for all the wall anchors.
If your installation requires a filler jamb, position the filler jamb over the holes.
Secure a wall jamb in place (over the filler jamb if needed) using four provided panhead screws.
Repeat for the other wall jamb, skipping filler jamb procedures.
Remove the bottom track and thoroughly clean the shower ledge.
Wall Jamb
Wall Jamb
Top View
Wall Jamb
#8-18 x 2"
Panhead Screw
Filler Jamb
Filler Jamb
With Filler Jamb
Without Filler Jamb
Anchor
Drill holes.
Press and hold legs together.
Sterling
7
1034028-2-F
Содержание STERLING 6500 Series
Страница 41: ...1034028 2 F ...
Страница 42: ...1034028 2 F ...
Страница 43: ...1034028 2 F ...
Страница 44: ...USA 1 800 STERLING 1 800 783 7546 México 001 877 680 1310 SterlingPlumbing com 2009 Kohler Co 1034028 2 F ...