Kohler SDMO DIESEL 10000 E XL C, Инструкция по эксплуатации и техническому обслуживанию

Страница: 23 / 254

5.3.4 Cleaning the generating set
To ensure it continues to run correctly, the unit must be cleaned regularly. If the unit is installed inside, always check that the
installation is clean and in good condition. If the unit is being used outside (building sites, dusty, muddy or densely wooded areas,
corrosive environment, etc.), it must be cleaned more frequently.
Use of water sprays or high pressure cleaning equipment is prohibited as this may seriously damage the unit .
1. Use a brush to gently clean the engine air intakes and outlets and, if present, the spark arrester.
2. Clean the unit with a sponge and water mixed with a mild detergent (car shampoo, for example), then rinse with fresh
water to remove all traces of the cleaning product.
A cleaning foam may be used and wiped off using a soft, absorbent cloth. Stubborn stains may be removed using a suitable solvent (white
spirit or equivalent) and wiped off using a soft, absorbent cloth.
3. Check the general condition of the unit (no leakage, tightness of nuts and bolts, connections and hoses, etc.)
4. Apply an anti-rust product to damaged areas, change defective parts and damaged labels if necessary.
Only use original parts and consult an agent if necessary.
6 Transporting and storing the generating set
6.1 Transport and handling conditions
The unit should be handled gently and brusque movements should be avoided. Ensure that the place where it is to be stored or
used is carefully prepared beforehand. Before transporting the unit, check that the bolts are correctly tightened, close the fuel tap (if
fitted) and disconnect the starter battery (if fitted). The unit should be transported in its normal operating position; never lay it on its
side. Ensure that the unit cannot fall from the vehicle carrying it, but without exerting too much constraint (risk of damaging the unit).
Before any fixed installation on a trailer, consult one of our agents.
6.2 Storage conditions
This procedure for storing the unit or protecting it over the winter must be respected if it is not used for a period of up to 1 year. For
longer periods of storage, it is recommended to contact your nearest agent or to start up the unit for a few hours every year,
ensuring that the storage procedure is respected afterwards.
1. Start the unit and allow it to operate until it runs out of fuel.
2. With the fuel tap open, replace the fuel filter (A16-C2).
The fuel circuit will drain, ensuring that the unit remains in good condition.
3. Close the fuel tap (A4-C1).
4. Disconnect the battery (A2).
5. Top up the oil.
6. Replace the air filter (A9).
7. Clean the unit and cover it with a protective cover.
8. Store it in its normal position, in a clean, dry and well ventilated area.
7 Repairing minor faults
7.1 APM202 faults and alarms
Pictograms
Colour of
the LED
Type of fault Issue Possible solution
Red Overspeed
Shutdown: generating set rotation
speed excessive
Contact one of our agents.
Flashing
red
Speed too low
Shutdown: insufficient generating
set rotation speed
Contact one of our agents.
Red Fail to start
3 or 6 unsuccessful attempts
(depending on the engine type) in
succession
Check that the generating set has
been started according to the
recommendations in this manual.
Red
Oil pressure or low oil
level
Shutdown: incorrect oil pressure or
low oil level
Allow the generating set to cool
down, top up and check the oil
level.
Red
Battery or charging
alternator
Problem with the alternator charge
output or weak battery
Contact one of our agents.
Red Engine temperature
Shutdown: abnormal engine
temperature
Allow the generating set to cool
down and check the air filter and
vents on the enclosure.
Flashing
green
Glow plug preheating
or choke
No issue: choke or plug preheating
sequence
-
19/250