Kohler Mira Logic, Руководство пользователя

Страница: 6 / 16

6 1292000-W2-B
Applicator
Clamp Bracket
Slide Bar
Constant Friction
Mechanism and
Friction Pad
25 mm Minimum
Spill-over level
Hose Retaining Ring
Note! For dry lined, stud partition, shower cubicle or laminated panel walls the installer may
wish to obtain alternative proprietary cavity fixings. Use of these alternative fixings is beyond
the scope of this guide.
Important! If the Logic slide bar replaces an existing Mira slide bar make sure that the
position of the shower control and the shower fittings provide a minimum of 25 mm between
the handset and bath/tray spill-over level. This is necessary to prevent back-siphonage. If
this is not possible then the new slide bar will have to be repositioned.
Mira Logic Exposed Variable Shower Fittings (ev)
Read the section:
Installation Requirements
before proceeding with the installation.
The slide bar should be positioned to one side of the shower control at a convenient height
for all the family. It should be positioned so that the handset discharges down the centre line
of the bath, or across the opening of the shower cubicle. The handset should be directed
away from the shower control.
1. Decide on a suitable position for the slide
bar avoiding buried cables and pipes.
Make sure that when the hose retaining
ring is placed on the lowest position on
the slide bar there is a minimum of 25 mm
between the handset and bath/tray spill-
over level. This is necessary to prevent
back-siphonage.
2. Important! The slide bar has been
supplied with an applicator fitted to one
end (refer to illustration) to assist the
assembly of the slide bar through the
clamp bracket.
With the clamp bracket button FULLY
depressed carefully ease the slide bar
through the hole in the clamp bracket.Take
care not to dislodge the constant friction
mechanism or the friction pad.
3. Release the clamp bracket button.
Remove the applicator from the slide bar
and store in a safe place for future use.
4. Slide the hose retaining ring onto the slide
bar below the clamp bracket.
Installation
8. The minimum pressure required for a satisfactory spray pattern to form, at the handset or
spray head, is 0.1 bar. For a gravity fed shower installation the minimum head of water
required, to accommodate the pressure loss in the pipes and shower control of a typical
installation, is 1.0 metre.
For a pump installation the minimum acceptable vertical distance between the base of
the cold water storage cistern and the shower head to operate the pump’s flow switches,
is typically 0.6 m (600 mm).