Kohler Mira Advance 8.7, Руководство по установке

Страница: 32 / 40

32 1306246-W2-D
Fault Indication
Start/Stop Status Code Cause Initial Action
On
Flashing
Red Blue
G
Start/Stop button
stuck
Contact customer services.
Flashing
Red White
J
Relay Board failure
Contact customer services.
Should the fault remain after the initial action, press and hold the ‘Start/Stop’
button and note the Status light sequence.
Off Flashing
Red White
Cover PCB failure Contact customer services.
Off
Flashing
Yellow
B
Communication issue
between the shower
and pump
Confirm the transformer to the
pump is switched on and it’s power
light should be flashing Green.
Confirm the shower and transformer
are with range. See Bluetooth
setup. If the transformer is out of
range a hardwire connection may
need to be installed.
Contact customer services.
Flashing
Yellow Blue
K
Shower and pump
transformer not paired
Pair units, ensure the dip switches
on both units are correctly set.
Flashing
Red Yellow
C
Thermistor fault Check thermistor connection (CN3)
to relay board.
Contact customer services.
Flashing
Red Blue
E
Flow Valve fault
Contact customer services.
Flashing
Red White
H
Cover PCB failure
Contact customer services.
Off L Electrical Fault Check power to the shower
Should the fault remain after the initial action, press and hold the ‘Start/Stop’
button and note the Status light sequence.
Off
Flashing
Yellow
Communication issue. If the
transformer and shower can't be
paired because of range issues
a hardwired connection will
need to be installed.
Communication issue. If the
transformer and shower can’t be
paired because of range issues a
hardwired connection will need to
be installed.
Flashing
Red White
Cover PCB failure Contact customer services.
Additional Notes!
Shower Temperature - If the shower maximum temperature is too cold or too hot, check the configuration
of switches. Refer to section - SET UP .
Shower Tray Will Not Empty -
If the shower is in running mode (water is coming from the handset) but the
drain pump is not running, check that the pump has power and is operational. Refer to section - SET UP .