Safety
Operation and Maintenance Manual
Prevent material damages
ISO 7010 / M002 Observe the instructions
– In order to ensure that all residual risks are known by the personnel, the system
documentation must be read and understood.
Make sure that all residual risks according to the risk assessment of the system
manufacturer are reflected in the system documentation.
Provide documentation to the personnel according to the "target audience"
definitions without restrictions.
2.9 Prevent material damages
– Replace jointing material (e.g. O-rings, seals etc.).
– Check reusable removed parts for re-usability; see the relevant information in
the Service Manual and repair instructions.
– Replace any removed parts that cannot be re-used.
– If no specific torques and tensioning instructions are specified: Flange joints are
to be tightened with the standard torques. Additional information can be found in
the "Standard torques" chapter.
– Replace self-locking flange joints.
– Clean the Diesel engine, connections and flange joints thoroughly of oil, fuel or
care products before assembly.
– Use lint-free cleaning rags.
– Do not touch electric contacts. The connection is affected by dirt or components
may be destroyed by electrostatic discharges (ESD).
– Before cleaning the Diesel engine, cover or tape shut all openings into which
water, steam or detergents must not penetrate due to safety or functional
reasons.
– Remove the covers/seals after cleaning.
– Check the fuel lines, Diesel engine oil lines and hydraulic lines for the following
defects:
•
Leaks
•
Loose connections
•
Chafe marks
•
Damage
– Make sure the electrical power supply is firmly connected when starting.
– Make sure the engine is switched off before disconnecting the electrical power
supply.
– Use suitable test leads for measurements at plug connections.
– Protect the engine control unit against dust and water if no mating plug has
been connected.
32
© 2018 by Kohler Co. All rights reserved.
KD36V16 33521029701_1_1 en 2018-08-01
