8
1012557-2-
A
Kohler Co., Kohler, WI U.S.A.
6. BEFORE INSTALLING SPOUT AND HANDLES
REMOVE PIPE PLUG
Ensure that the valves are closed (cold - fully
counterclockwise, hot - fully clockwise).
Turn off the main water supply.
1/4” Pipe Plug
Close
Cold
Close
Hot
WARNING: Risk of personal injury. Lines may be
pressurized. Do not lean over pipe plug when
turning or removing the plug.
Wrap a towel around the pipe plug to prevent water spray.
Water may purge from the supply tube when you remove
the plug.
Carefully remove the pipe plug.
Fig. #15
7. INSTALL SPOUT
Remove the plaster guard from the spout supply tube.
Cut off the spout supply tube 1-1/4” (3.2cm) above the rim,
finished deck, or tile.
Ensure that all burrs are removed from the supply tube to
prevent damage to the O-ring seal on the sleeve.
Fig. #16
1-1/4” (3.2cm)
Tile
Finish
Rough
Deck
NOTE: The following step is applicable to a tile covered
rough deck installation only.
Slide a brass washer, flat side facing forward, onto the
supply tube. The brass washer is furnished with the spout.
NOTE: The washer is not needed for rim/finished deck
installation.
Fig. #17
Spout
Supply
Tube
Rough
Deck
Finished
Deck
Washer
