Kohler K-3900X, Руководство по установке

Страница: 7 / 36

Kohler Co. 7 1195109-X2-A
Install the Remote Dock
NOTE: The docking station comes with a 5 meter cord. Locate the docking station to allow the docking cord
to reach the toilet.
¨
Unpack the box containing the remote control components.
¨
Remove the small screw on the bottom of the docking station.
¨
Carefully remove the cover plate by plug the tool into the gap on the top of the back, gently prying the sides
of the cover plate out until they disconnect from the dock. (see Fig. #2)
¨
Carefully disconnect the cover plate plug.
¨
Tape the screw to the cover plate and set it aside.
¨
For installations using the concealed type, route the power cord through the back cord opening.
¨
For installations using the out-loading type, route the power cord through the bottom cord opening.
¨
Position the docking station in the installation position and mark the screw locations using the dock as
a template.
¨
Drill appropriate size mounting holes at the screw mounting locations. The size of the hole will depend
on the need for wall anchors, wall material, and installation requirements.
¨
Loosen each of the five small screws located where the wires will be connected.
¨
Run the power cord into the docking station through the back cord opening in concealed type or the
bottom cord opening in out-loading type.
¨
Position the docking station over the installation location, connect the docking station to the wall using two
screws.
¨
Cut the tin (about 2 mm) of the bare end of the wire.
¨
Slide the bare end of the wires into the correct port (see Fig. #3) according to the color and tighten each screw
to secure the wires in place, connect the cover plate plug.
¨
Snap the cover plate back into place.
¨
Remove the screw and tape from the cover plate and secure the cover plate with the screw to the docking
station.
Holes
Red
Blue
White
Black
Orange
Screw Fig.#1 Fig.#2
Fig.#3 Fig.#4
Connector
Harness
Docking Cord
Back Cord
Opening
Bottom Cord
Opening
Back Cord
Opening
Disconnect.