1106828-2A-AA/Rev04
Assemble thumb screw(22) to link(21), and link onto ball lever rod
(20) with "V"-clip(23). Slide lift rod(5) through the hole of the link.
Position the lift rod so that the length between the top of the lift rod
and the mounting surface can not exceed 60mm when the drain is
closed.
Push the ball lever down into the open position .
Tighten thumb screw.
Ensure that all connections are tight.Ensure that the handle is in the
off position.
Open the drain. Turn on main water supply and check for leaks.
Repair as
required.
Remove aerator(24). Turn on the faucet. Run hot and cold water
through spout for about a minute to remove any debris. Remove
any debris from aerator. Shut off the faucet and reinstall aerator.
All Finishes: Clean the finish with a mild soap and warm water. Wipe entire surface completely dry with
a clean soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner
etc. which could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
20
23
21
22
5
Do not reposition the drain after
the locknut is tightened,
or you may break the putty seal.
24
