1106828-2A-AA/Rev04
Install the mounting stud(2) onto the faucet body base(3). Insert lift rod
(5) to the hole of the body. Slide the washer(4) over the flexible hoses(1)
and mounting stud(2), and into the groove at the bottom of the faucet
body.
Insert the flexible supply hoses(1) into the lavatory hole. Position the
faucet. From underside of the lavatory, place the bracket(6)(Rubber
washer is on the top) onto the mounting stud, and secure the faucet with
the nut(7).
Attach the hoses to water supplies. When facing front of faucet , the left
hose connects to hot water, the right hose with "COLD" label connects to
cold water.
Remove flange(8) from drain body. Slide the washer(9) onto the
underside of the drain flange. Apply thread tape to tailpiece (10). Install to
drain body(11). Insert drain body into underside of lavatory with drain
lever hole(12) facing to the back of lavatory and thread flange(8) onto
drain body until hand tight. Tighten the locknut(13) by hand from the
underside of the fixture.
Place stopper (14) into drain body aligning the flat side of stopper hole
(15) with the drain lever hole.
Place the rubber washer(16) into the drain lever hole(12). Put another
plastic washer (17) and retaining nut(18) into the long end of ball lever rod
(19). Insert the ball lever assembly(20) into the drain lever hole and
through the stopper hole(15), and tighten the retaining nut(18).
Be sure that the ball lever points to the back of the lavatory. Tighten the
locknut (13) onto the drain body. Remove any excess putty.
If needed apply a ring of plumbers putty around the underside of
the drain flange(8), instead of using washer(9).
19
18
20
13
16
17
9
8
13
12
10
11
8
14
15
2
3
5
4
1
6
7
