TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
·
·
·
·
·
·
·
·
·
·
Sealant
Template (supplied)
Safety glasses
Pencil
Scissors
Tape Measure
Hole Saw
Keyhole saw or saber saw
Dill (1/2" dia. Drill bit, or larger)
Screwdriver
·
·
·
·
·
·
·
·
·
·
(
)
(
13mm
)
-2-
Position the template on the
countertop.
Be sure to
provide sufficient spout overhang into
the lavatory basin. See the roughing-in
notes for minimum spout length
information.
Pay special
attention to the spout and handle fit
clearance when locating the faucet, as
noted below. Use the template to
locate the faucet spout hole centerline
on the countertop. This centerline is
recommended to provide adequate
clearance between the edge of the
lavatory and the spout.
Check for adequate clearance
between the backsplash or wall faucet
spout and handles, and lavatory. We
recommend clearance of at least
25mm between:
The installed lavatory and the
faucet spout
The installed lavatory and the end
of the faucet handles, and
The faucet spout and handles and
the backsplash or wall.
Refer to the faucet installation
instructions for required clearance, and
mark the preferred faucet hole
locations using a soft lead pencil.
Trace the template on the countertop
using a soft lead pencil.
For Wall-mount faucets:
For Countertop Faucets:
·
·
·
NOTE:
In china installation will not
have separate backsplash. The back
wall is the "backsplash".
COUNTERTOP INSTALLATIONS
COUNTERTOP INSTALLATIONS
25mm
·
·
·
25mm Min.
Clearance
25mm
Spout
Centerline
Backsplash
Cut-out line
Outside Edge
of Lavatory
Fig. #2
2
1148744-T01-A
