Kohler EIR, Руководство для владельцев жилья

Страница: 15 / 48

Auxiliary keyboard function
Wide oscillate clean function
Standby
mode
The Bidet is equipped with wide oscillate clean function. If you would like to use wide oscillate function, push
and hold rear wash + STOP button about 2s before activate rear wash + oscillate function; activate oscillate
function.
1. Push and hold “ ” button (over 2s) on side panel, enter standby mode when generate one “beep”. Auto
detection and remote function deactivated at this point, so as I o T function (for I o T models), top indicating
LED OFF. Seat heating function deactivated to minimize energy consumption.
2. When press any button on side panel or seated, auto exit standby mode, all function recovered.
D 1. Standby
mode
A. Press button to
enter front wash
Note:
1. Each function performance shall conform to factory setting.
2. When use the front wash/rear wash mode, activate corresponding function, auto deactivate after 5min.
D. Press button to stop all functions.
B. Press button to enter
rear wash
F. When unseated, push and hold rear or front wash
Push and hold (more than 2s) “ ” button to enter
standby mode, details are shown in Page
15
“standby
mode ” item.
2. Stop function
Press “ ” button to stop flush, dryer, air purification,
One button sterilization function, manual nozzle clean
and UV function.
C. Light sensor area
E. Press to perform flush full, push
and hold “ ” for 2s to enter
emergency flush mode when
power is off.
button until nozzle extension, perform manual clean
for nozzle, press “ ” button to deactivate manual
clean function.
Deactivate front wash/rear wash/dryer function by pressing "
Use " " button to flush bowl. "button. 3.
4.
Bidet nozzle
UV radiation range Bidet nozzle
Kohler Co. 15 1413624-T01-B