209-1023 CLC Cabinets
3
Mounting location for
#8 x 1 1/2" philips
head screws
25 1/4" high
14 1/4"W for CLC15 Models
19 1/4"W for CLC20 Models
24 1/4"W for CLC25 Models
29 1/4"W for CLC30 and CLC3026F-3
models
34 1/4"W for CLC35 Models
35 1/4"W for CLC3626 Models
ROUGH OPENING DIMENSIONS
Cabinet bottom sits
in lip on bottom
mounting bar
#8 x 2" Hex
head screw &
Wall anchor
(use 1/4" driver)
11" bottom mounting bar for CLC15/20
21" bottom mounting bar for CLC25
26" bottom mounting bar for CLC30
31" bottom mounting bar for CLC35/36
INSTALLER’S NOTE:
Installing the cabinet on a wall without the door attached can make installing easier
for one person. Do not mount the doors until the box is in or on the wall.
Wall anchor
(if required)
Top mount clip
#8 x 2" Hex head screw
(Use 1/4" driver)
INSTALLER’S NOTE:
If you are using a CLL Top Light STOP HERE
and follow the CLL instructions.
2. Surface mounting the cabinet on a wall. *
A. Install Mounting Bar.
(Step one varies on type of cabinet
you have, see below.)
Fig. 3A – For Single Door
Fig. 3B – For Two Door
Fig. 3C – For Three Door
2. Drill 3/16” hole in wall for mounting bar anchors at locations
shown in Fig. 3. (If you do not use the anchor, drill a 3/32”
pilot hole.) After the holes are drilled, fit the mounting bar
onto the wall, refer to Fig. 3 for measurements, and Fig. 5
for information on anchor cinching.
B. Install Top Clips
(Left and right top clips come connected, hold
both clips and snap them apart).
1. Fit cabinet into position on mounting bar as
shown in Fig. 4A.
2. Place clip in position as shown in Fig. 4B and
mark with a pencil. Remove clip and cabinet and
drill the pilot or anchor holes where marked.
3. Fix both the clips into position with a screw, and
slide the clip into the up position. Sit the cabinet
on the mounting bar, then lower and tighten the
screws into place, as shown in Fig 4C.
4. See Fig. 5 on next page for proper turns required
for anchor cinching.
5. See page 3 for Side Kit Mirror application.
Fig. 4A
3/4"
4 1/2" from edge
Bottom of Cabinet
2" from edge
CLC20
CLC15
1. Drill two 3/16 holes in bottom mounting bar at indent
location. Use the supplied anchors or locate studs
if possible.
Side of Cabinet
3/4"
Bottom of Cabinet
2" from edge
1. Drill three 3/16 holes in bottom mounting bar at indent
location. Use the supplied anchors or locate studs
if possible.
Side of Cabinet
3/4"
Bottom of Cabinet
1. Drill four 3/16 holes in bottom mounting bar at indent
location. Use the supplied anchors or locate studs
if possible.
Side of Cabinet
2 1/2" from edge
2" from edge
CLC36
CLC30
