Kohler 97631-G9, Руководство по установке и эксплуатации

Страница: 8 / 68

3. Trim the Locker and Walls
Cut Wall Placement
IMPORTANT! The cut edges of the wall panels MUST be positioned opposite the locker unit. The vertical
edge of the locker unit MUST mate to an uncut, bevel molded edge on the wall panels.
Cutting the Walls and Locker
IMPORTANT!
It is recommended the wall panels be cut using a power saw and abrasive wheel or an
abrasive masonry blade.
IMPORTANT! Do not cut the sides of the locker unit. Only trim the top or bottom to fit your wall length.
IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is
placed upside down the shelves will fall out.
Position the back wall panel face down on a stand or sawhorses that have a protective material on
them.
Cut the back wall panel to the required dimensions. Use a jigsaw with a grit blade for contour cuts.
Repeat with the sidewall panels.
From the front side of the sidewall panel, use a hole saw to cut the holes for valving and other
shower components.
NOTE: Remove any protective films on the locker unit surface before cutting.
Cut the locker unit to the required height dimensions using a fine toothed blade.
IMPORTANT! It is critical the wall panels and locker unit are clean for a strong bond to be created by the
adhesive.
Remove excess material and sand any rough edges using a sanding block.
Clean the back of the wall panels and locker unit with denatured alcohol.
Back Side
Sanding Block
Cut Edge
Uncut Edge
Sidewall
Panel
Shower Valving
1248925-2-C 8 Kohler Co.