Kohler 97631-G9, Руководство по установке и эксплуатации

Страница: 5 / 68

1. Prepare the Site
IMPORTANT! Water resistant wallboard backing material is recommended.
Install the rough plumbing for the bath and shower components.
Check the studs for plumb. Studs should be within 3/8
″
(10 mm) of plumb, shim if necessary.
The ledge of the locker unit can be used as a footrest. The recommended footrest height is 12” (305
mm) to 16” (406 mm), from the floor of the shower to the ledge of the locker unit.
Determine the height of the enclosure and the locker unit.
Install 2x4 bracing where the locker unit will be placed following the dimensions shown above.
To determine the height of the bottom bracing, subtract 1” (25 mm) from the desired height of the
footrest.
Install backing support for all accessories that require additional support. Refer to the installation
guides packed with each product for specific installation needs.
Install wallboard backing material over the locker unit opening with the same dimensions as the 2x4
bracing cut out.
65"
(1651 mm)
K-97630: 9" (229 mm)
K-97631: 14-1/2" (368 mm)
2x4 Bracing
K-97630: 9" (229 mm)
K-97631: 14-1/2" (368 mm)
Wallboard
Backing
65"
(1651 mm)
11" (279 mm) Min
15" (381 mm) Max
11" (279 mm) Min
15" (381 mm) Max
Kohler Co. 5 1248925-2-C