Koenic KAC 12020 CH WLAN, Руководство пользователя, Страница: 47 / 292

47
English
Preprogramming a function
By pushing the
SHORTCUT
button any
function and temperature can be saved and
recalled.
• Choose your desired function e.g. using
the MODE, TEMP / + or / – and FAN
buttons, etc.
• Press and hold the SHORTCUT button until
the display flashes once to save the setting.
• The preset setting can be recalled anytime
and from any mode by simply pushing the
SHORTCUT
button.
Fig.
11
Water drainage
Water is only collected during automatic AUTO ,
cooling COOL and dehumidifying mode DRY .
During dehumidifying mode DRY water
is drained immediately through the upper
drain outlet and the drainage hose must be
continuously connected.
The water must be drained through the hose
into a suitable container or nearby drain using
the upper drain outlet.
Warning
Danger of flooding!
Do not leave the
product unattended when draining to an
external container! Empty the container
frequently to avoid spilling over and water
damage.
Note:
If the water is not drained to an external
container and the upper drain outlet is closed
during automatic AUTO or cooling mode
COOL water is collected in an internal tank,
which must be drained when full. In this case
the product will emit an audible signal, while
the display on the control panel is showing
the protection code P1 . The cooling process
will stop until the water is drained and the
product restarted, while the fan remains
running.
• Disconnect the product from the power
supply.
Fig.
10
Setting the timer
The timer switches the product on or standby
when a user-defined time has elapsed. When
switching on, the last mode and setting will be
used.
The set durations will be counted down
immediately.
• Press the timer program button TIMER at
the product or the specific TIME ON/OFF
button at the remote control to enter the
timer setting for either the auto-on or auto-
off timer. The respective indicator for each
setting will light up.
• Press the + / – buttons or the specific TIME
ON/OFF button at the remote control as
often as necessary to set a time from 0.5 to
24 hours.
• The setting will be saved in the product
after 5 seconds without input.
Note:
The indicator lights are on when the timer is
activated.
Examples:
• To have the product switch into standby
after 1 hour and on again after another 1½
hours, set the auto-off time to 1.0 h and the
auto-on time to 2.5 h during operation.
• To have the product switched on after 8
hours and standby after another 8 hours,
set the auto-on time to 8.0 h and the auto-
off time to 16.0 h while in standby.
Note:
• The adjusting increments are 0.5 hours up
to 10 hours, then 1 hour up to 24 hours.
• The respective indicator will be lit, when a
time is set.
• Switching the product on or into standby
manually will cancel the timer setting.
• The timer settings will be lost once the
respective actions were conducted and
the time needs to be set again. The timer
setting will be lost in case an error occurs
(see protection and error codes).
IM_KAC12020WIFI_191120_V02_HR.indb 47 25/11/2019 08:54