Koenic KAC 12020 CH WLAN, Руководство пользователя, Страница: 44 / 292

44
English
Size - A5
Control
panel
Remote
control Function
ON/OFF
Switch on or into
standby
+
TEMP
Increase value, e.g.
temperature or timer
TEMP
Decrease value of
temperature or timer
MODE MODE
Mode selection button
FAN FAN
Fan speed selection
button
SLEEP SLEEP
Comfort mode on/off
SWING SWING
Fan outlet oscillation
on/off
—
LED
Display and indicator
lights on/off
TIMER
on
off
+
–
TIMER
OFF
Adjust switch into
standby time
TIMER
ON
Adjust switch on time
— SHORT
CUT
Choose preset mode
and temperature
— FOLLOW
ME
Precise temperature
control
Note:
The device is equipped with a self-
evaporating system. The condensing water
is self-evaporated and released through the
air exhaust. Please note, that nevertheless,
depending on the set mode, water will be
collected in the internal tank or drained
through the hose.
Operation
Fig.
5
Switching on/off
The product can only be switched on
or into Standby. Unplug in order to
disconnect from the mains.
Press the on/off button or the ON/
OFF
button to switch the product on or
into standby.
Note:
• After a power break or when the product
is switched into standby and on again in
a short time, the refrigerating compressor
will resume work after 3 minutes (delayed
start). This is to prevent the cooling circuit
from damages.
• If the product is tilted over, switch it into
standby and unplug immediately. Wait
at least 2 hours before operating the
product again to avoid damages on the
refrigerating circuit.
• Always switch the product into standby
before unplugging.
Remote control
Fig.
6
Remove the battery compartment cover.
Insert 2 batteries (type R03/ AAA) while
paying attention to the correct polarity.
Close the battery compartment. Using
the control panel and the remote control
alternately might lead to a misalignment
of the product and the information
displayed on the remote control.
Note:
• Press any button on the remote control
and the product adopts the current
setting from the remote control.
• The signals of the remote control will
be transmitted with a short delay after
a button is pressed. This process is
indicated by the appearing symbol on
the remote control display.
• Every press of a button on the remote
control will illuminate the display on the
remote control for a few seconds for
better visibility in the dark.
IM_KAC12020WIFI_191120_V02_HR.indb 44 25/11/2019 08:54