6
Assembly Instructions
The use of protective gloves and eyewear is recommended during assembly.
Step 1 -
Stake the Tent
Stake
each of the tent’s four corners making sure that the tent is taut and square. Note: Do not stretch
too tightly. Do not pull or yank on stake loops, or damage could occur. Continue to place a stake through
each of the remaining stake loops.
Tips:
Drive in stakes with the tip angling toward the tent. Secure the hooks on the end of the stakes over
the tent stake loops.
In soft sand or snow, use a dead-man anchor. Bury a horizontal piece of wood approximately 12
– 18
inches deep with a guyline connecting to the stake loop.
Make sure that the anchor is secure.
For windy conditions additional guylines should be used (sold separately). Secure guylines to tent
frame, and tie to a tree, unmovable object, or stake into the ground. It is also recommended to face
the narrow end of the tent into the wind.
It is better be a little loose than too taut. Pull on the tent body not the stake loops.
WARNING
This tent is not free-standing. If not properly staked it will
collapse. Be sure to securely anchor the tent.
Содержание 6160
Страница 5: ...5 Tent Poles ...
Страница 9: ...9 Figure 2 Frame Diagram ...