MDC-3560P/3510P Series
Chapter 4
INSTALLATION
93142002-02
4-1
CHAPTER 4 INSTALLATION
4.1 Installation considerations
General
Qualified personnel should perform the installation of the MDC-3560/3510 series. The
installation comprises the following operations.
(1) Unpacking each component of the system.
(2) Inspection of the exterior of each component unit and accessory.
(3) Checking the ship’s mains voltage and current capacity.
(4) Determining the site of installation
(5) Installing the Antenna Unit.
(6) Installing the Display Unit
(7) Installing the accessory items
(8) Planning the cable routing and connections
(9) Commissioning
4.2 Unpacking each component of the system
Unpack your package and check if all of the items stated in the packing list are
contained in the package. If not, report this to the insurance agent for tracing missing
goods or refund.
4.3 Inspection of each component unit and accessories
Carefully check the exterior of each component unit for dents, damage, etc. Also
check the inside of component units for electrical and mechanical damage. The
Cathode Ray Tube is a fragile item, which is easily broken if the display unit is
accidentally dropped.
4.4 Siting the units
To achieve best operational performance, the following factors must be considered.
4.4.1 Antenna Unit
(1) The radar antenna should be mounted on the center line of your ship where no
large obstacles interfere with the path of the radar beam.
(2) Location should be as high as possible, however, keep in mind that nearby objects
may be overlooked if mounted too high. Also note that the higher the antenna, the
higher the level of sea clutter.
(3) The mounting surface should be as flat as possible and approximately parallel
with the vessel’s water line.
