Koden MDC-2000BB Series, Руководство по эксплуатации, Страница: 93 / 112

MDC-2000BB Series Chapter 5 Equipment
0093120012-01 5-31
Connection of DC power cable (CW-259-2M)
Grounding
● Use the large diameter cable for ground wire as possible.
● Connect the ground wire to the ground material at a shortest distance.
● When connecting the external equipment whose positive polarity is connected to the ground line,
do not connect the ground of the signal line to the cabinet ground.
Connection with the AIS Receiver (J2) (Prepared by a user)
Use the CW-387-5M (Optional) when installing the AIS receiver. For connecting any equipment, one
end of the CW-387-5M is left un-treated. Prepare a connector suitable for the equipment you desire to
connect.
The connection cable (CW-387-5M) consists of 14 core wires (7 pairs) and the shield wire around them.
A signal is inputted from the blue (AISIN+) and white (AISIN-) wires.
For connection of the CW-387-5M and AIS receiver, refer to the illustration below.
When cables are connected, please perform the waterproof and insulation treatment on the junction
with self-bonding tape or similar materials.
Structure of CW-387-5M
Connection with the navigation equipment (J5)
Two NMEA0183/IEC61162 input/output ports are provided. Connect the navigation equipment and the
external equipment such as KODEN made GPS sensor to them. The optional cable with connectors at
both ends is available. The CW-376-5M of which one end is left untreated is also available. Prepare a
cable suitable for the equipment you desire to connect.
The connection cable CW-376-5M consists of six core wires and the shield wire around them. A signal
is outputted from the white (NMEA TX+) and red (NMEA TX-) wires, and a signal is inputted from the
orange (NMEA RX+) and black (NMEA RX-) wires.
For wiring of CW-376-5M, refer to the illustration below.
When cables are connected, please perform the waterproof and insulation treatment on the junction
with self-bonding tape or similar materials.
To [POWER] connector
GND (Gray)
DC- (Black)
DC+ (White)
To AIS receiver
Insulate other wires (including the shield wire)
2 AISIN+ blue
3 AISIN- white