Koden MDC-2000BB Series, Руководство по эксплуатации

Страница: 37 / 112

MDC-2000BB Series Chapter 1 Basic Operation
0093120012-01 1-12
1.16 Measuring the distance
and bearing between two
points
The distance and bearing between two points,
you desire, can be measured, using the cursor.
How to operation
1
Move the cursor to one point desired with
the [
], [ ], [ ] and [ ] keys.
2
Press the [ENT] key to set it as an origin.
3
When moving the cursor with the [ ], [ ],
[ ] and [ ] keys, the distance and bearing
from the origin to the position of the cursor
are displayed.
4
When pressing the [MENU] key, the 2-point
calculation is finished.
1.17 Camera Display
The video of the CCD camera can be displayed
on the radar screen. (CCD camera: Prepared by
a customer)
How to connect the CCD camera
1 Connect CW-405-0.3M cable (optional
cable) to the J6 in the rear connectors.
2 Connect a commercially available CCD
camera to the cable.
How to display the video of the CCD
camera
1
Press the [F1-6] key with the CCD set.
The video of the CCD camera appears.
A
split-screen
display, a full screen display
and non-display are toggled by pressing the
[F1-6] key.
2
When pressing the [ ] or [ ] key in the
state that a video of the CCD camera is
displayed, the display position of the video
of the camera video can be corrected.
3
When displaying the video of the CCD
camera, if a key other than the
[STBY/TX],[RANGE], [
] and [ ] keys is
pressed, the video of the CCD camera
disappears.
cursor
cursor position
cursor bearing
cursor distance
origin
cursor
cursor position
35
°
24.334N
139
°
0.903NM 152.1
°
45.831E
Distance between the origin
and the cursor
Bearing of the cursor
when viewed from the origin
When displaying the video of the CCD
camera, the display area of the radar
image is narrowed.
When set to [Full Screen Display], the
radar image is completely concealed.
When displaying the video of the CCD
camera, pay attention to the display
area.
Caution