Printer Options 2-7
Reference Guide
A few rules regarding the End of Media feature:
• will not work with Cut Sheet selected as supply type.
• setting is remembered across power cycles.
• setting is not stored as a user parameter.
• setting cannot be changed once a plot begins to print.
• if you press PAUSE to resume the print, detection is disabled for the remainder of
the print.
• if enabled, detection is reinstated at the beginning of each print.
• when the printer is in pause mode due to End of Media, the printer will beep 3
times every 20 seconds until the PAUSE or RESET buttons are pressed.
ê
To set end of media
1
Press
Feed Media
Menu
/End of Media
.
2
Choose
Feeder Stop
or
Normal
.
3
Press
OK
.
Media counter
Media Counter gives you a means of
estimating
the amount of media left on a roll.
When a new roll of media, or a used roll where the remaining length is known, is installed
on the printer, you can enter the length of the roll into the printer's front panel display. As
the printer prints, this amount is decremented. You can view the estimated amount of
media remaining on the printer's front panel display. When you are ready to remove the
roll, you can print the estimated amount of media remaining on the roll. When you reload
this media, you can use this figure to enter into the printer's front panel display. The
media counter can be reset to 0 to avoid confusion if the media counter is not being used.
The media counter will not decrement below 0. The current value of the media counter
is maintained across power cycles. The current value is not stored as a user parameter.
ê
To enter a media length value
1
Press
Feed Media
Menu
/Media Counter
.
2
Set the media length.
3 Press
OK
.
