Kodak 210433-1, Руководство пользователя

Страница: 20 / 112

1500 TX User's Guide
2-6 Getting Started
Using at least three pieces of tape, attach the leading edge of the media
to the take-up roll at the left, right, and center of the core.
As printing progresses, the media is looped down in front of the take-up
core until it is detected by the sensor on the printer leg. The take-up roll is
then activated to roll the media.
Be sure not to block the sensor!
Note: If you are running narrow media, and depending on ambient
temperature and humidity, you may want to set a dry time and/or turn on
the dryer as described in Chapter 3 if you are running a long plot.
Because of the print speed and the narrow media, the ink may otherwise
not have sufficient time to dry before the media is rolled onto the take-up
core.
➪ ➪
➪ ➪
➪
To unload the take-up roll
1 Press the Cut button to cut the media.
2 Remove the roll from the printer and release the adjustable roll guide.
Moving the carriage
When not in use, the cartridges rest in the service station at the right side of the
printer. This device seals the inkjets to prevent them from drying out. If power is
turned on, always use the Utility/Access Cartridges button to move the
carriage away from the service station so that you can install, change, adjust
or clean the ink cartridges or the service station.