Troubleshooting I-9
1500 TX User's Guide
APPENDICES
Line drawings exhibit bleeding
Be sure you are printing on the coated side of the media. Roll feed media
should be loaded so the coated side is on the outside.
If your application software permits, use gamma correction to lighten the
color.
Too much air may have been drawn into the cartridge during extended
operation. Add 5 ml of ink and reinstall the cartridge.
Colors print as monochrome
Be sure the Color/Mono mode is set correctly. To change a specific
drawing from monochrome to color or vice versa, you must switch the
Color/Mono setting and re-transmit the file.
Ink smears after removing the print
Be sure the ink is dry before removing the print. If you are printing area
fills, you may want to set the Dry Time option. (See "Setting a Dry
Time" in Chapter 3.) Turn the dryer on.
Smudged or dark characters
Be sure you are using the correct type of paper for the application. (See
Appendix G.)
Make sure the paper is straight and unwrinkled when loading it into the
printer.
Prime, clean, calibrate, or replace cartridges.
Try a different print mode.
Improperly formed or misaligned characters
Calibrate cartridges.
Color problems or shadowing
Calibrate cartridges.
Содержание 210433-1
