|
10
NEO 01/0820
Rev A
Getting Started
Section Two
SETUP OVERVIEW
Below highlights the initial steps in setting up your sensor for operation.
1.
Check Part Number
(Section Two)
a. Confirm that the sensor’s part number matches the ordered part number and all components
are provided with the model delivered.
2.
Measurements, Installation & Software
(Section Two)
a. Understand the location placement of the sensor relative to Measurement Range including
Sensor Height and Fill-Height settings.
b. Download the NEOCal software from www.koboldusa.com.
3.
Configure Sensor with NEOCal software
(Section Three)
a. Section 3 contains information on using the NEOCal software.
4.
Configure Sensor with Push Button
(Section Four)
a. Section 4 contains information on using the Push Button Display to configure the sensor.
5.
Install the sensor
(Section Five)
a. Section 5 contains information about the sensor location placement and its mechanical
installation.
6.
Wire the sensor
(Section Six)
a. Section 6 contains information about the sensor’s electrical wiring and power requirements.
Note: When configuring NEO-7 series, choose either the NEOCal software or Push Button method. Either
method will accomplish the goal of sensor configuration. Changes to the configuration can be made using the
alternative method. When beginning with one method, it is recommended to complete the configuration before
using the other method to make any adjustments.
COMPONENTS
NEO-7 is offered in different models. Depending on the model purchased, you may or may not have been
shipped all the components shown below.
P/N
Max.
Range
Dead
Band
Thread
Rating
Output
Configuration
NEO-7006
19.7’
(6m)
8”
(20cm)
2” NPT
General
Purpose
4-20 mA
Display
with
Push Button
or
NEOCal
software
NEO-7006-IS
Intrinsically
Safe
NEO-7012
39.4’
(12m)
18”
(45.7cm)
3” NPT
General
Purpose
NEO-7012-IS
Intrinsically
Safe
Manual
