Kobold MAS Series, Инструкция по эксплуатации

Страница: 14 / 54

MAS Instruction Manual
Page 13
As shown in Figure 2-4, the digital display on your MAS may be
removed and mounted remotely on a front panel. The MAS
transducer is mounted at any convenient location in your system.
Remote installation is not recommended unless you possess the
proper soldering tools and skills to accomplish the job. Remote
installation of the digital display is accomplished by following
these steps:
1. Remove the digital display from your MAS by following the
procedure described in Section 2.5.3, OEM E
LECTRICAL
C
ONNEC
-
TIONS
.
2. Gain access to the printed circuit board (PCB) also by following
the procedure in Section 2.5.3, OEM E
LECTRICAL
C
ONNECTIONS
.
3. Very carefully unsolder the four short leads from the PCB to the
display.
4. Gain access to the display circuit board by removing the two
snap rings (No. 36) and opening the “clam shell” display enclo-
sure. Remove the four short wires by carefully unsoldering.
Solder the longer four wires (26AWG, 100 ft. max shielded cable
recommended) to the digital display and solder the other ends
to the appropriate pin numbers of the 9-pin “D” connector as
shown in Figure 2-3 and Table 2-1 (on previous page).
5. Reassemble the MAS, replacing the display base (No. 35) with
the Model TP Plain Top Cover (No. 28).
6. Make the necessary plumbing connections to the unit.
7. Mount the digital display as shown in Figure 2-4 referring to the
panel mounting hole dimensions in Section 1.3, S
PECIFICATIONS
.
2.5.2
Remote Installation of
Digital Display
Figure 2-4
Remote Installation of
Digital Display