koban KDP-DALI-02, Инструкция по эксплуатации, Страница: 98 / 120

Installation tips specially for DALI dimming presence detector
Function
•
•
•
•
•

•
The  detector  should  be  placed  in  room  where  it  can  measure  both  natural 
light  and  artificial  light  simultaneously.
Direct  light  on  the  detector  from  any  illumination  should  be  avoided.
You  should  be  away  from  the  detector  to  avoid  affecting  the  luminous  flux 
that  reaches  the  detector  when  making  Lux  value  setting.
Do  not  install  the  detector  directly  next  to  a  window  or  sun  blind
which  can  cause  incorrect  measurement  on  the  natural  light 
(Refer  to  FIG.4-E)
>1m <1m
FIG.  4-E
Auto mode
Under  Auto  mode,  the  load  will  turn  on  automatically  when  the  movement 
is  detected  and  the  ambient  light  level  is  below  the  Lux  setting  value. 
When  no  movement  is  detected  and  the  delay  time  has  expired,  the  load 
will  (turn  off)  move  to  standby  mode  automatically.
According  to  the  changeable  ambient  light  level,  detector  can  postpone 
load′s  delay  time  of  turning  on  and  off  to  avoid  load′s  unnecessarily 
switching  on  or  off  due  to  rapid  ambient  light  change:
Ambient  light  level  changes  from  bright  to  dark:  If  the  ambient  light  level 
keeps  to  be  lower  than  the  preset  Lux  value  for  10sec,  the  light  will  be 
automatically  switched  on  after  10sec.  (LED  will  be  on  10sec  for  indication)
Ambient  light  level  changes  from  dark  to  bright:  If  the  ambient  light  level 
continuously  exceeds  the  switch  off  Lux  value  for  5min,  there  are  different 
reactions  according  to  the  time  setting  value.
Time  setting  ≥5min,  the  light  will  be  automatically  switched  off  after  5min.
Time  setting  <  5min,  the  light  will  be  automatically  switched  off  when  the 
set  time  reached  if  no  movement  is  detected  during  the  5min.  But  if  there 
is  movement  detected  within  the  5min,  the  time  will  be  reset  upon 
detection  and  until  5min  later,  the  light  is  switched  off.
Remark:  Both  DA1  and  DA2  have  the  above  mentioned  functions.
www.grupotemper.com 
KDP-DALI-02
Presence detector for DALI lighting control
Instructions  manual  |  38