koban KDP-DALI-02, Инструкция по эксплуатации, Страница: 108 / 120

After  user  choosing  the  desired 
detection  area,  the  redundant
lens  shield  should  be  eliminated.
Fixing  lens  shield:  There  is  slot 
around  the  lens  and  insert  the
lens  shield  into  slot  (See  FIG.17).
FIG.17
Walk test (Lux setting is invalid)
The  purpose  of  conducting  the  walk 
test  is  to  check  and  adjust  the
detection  coverage.  Set  Time  knob 
to“Test”,  then  conducting  a  walk
test.
KDP-DALI-02-M test procedure
Tester  must  be  within  the 
detection  coverage.
Switch  power  on.
KDP-DALI-02-M  takes  approx. 
60sec  to  warm  up  with
load  and  red  LED  or  green  LED  on, 
then  turns  off  after  warming  up 
time.
Walk  from  outside  across  to  the 
detection  pattern  until  red  LED  or 
green  LED  turns  on  for  approx. 
2sec  then  off,  the  nexttrigger 
should  be  2sec  interval 
(See  FIG.18).
Adjust  lens  shield  for  desired 
detection  range.
Repeat  step  4  and  5  until  it  meets 
user's  demands.
NOTE
It  takes  approx.  60sec  for  detector 
to  warm  up  after  power  is
supplied,  then  enters  into  normal 
operation  to  carry  out  a  walk  test.
FIG.18
1.
2.
3.
4.
5.
6.
www.grupotemper.com 
KDP-DALI-02
Presence detector for DALI lighting control
Instructions  manual  |  48