koban KDP-DALI-02, Инструкция по эксплуатации, Страница: 106 / 120

Lux learning function with
knob
Adjust  the  knob  to“  ”  when 
the  ambient  light  level  matches
with  the  desired  value  (See 
FIG.15-A).
When  the  knob  is  set  to“  ” 
originally,  it  should  be  adjusted  to
other  position  more  than  1  sec, 
then  goes  back  to“  ”
(See  FIG.15-B).
Then  the  load  is  off.  LED  starts  to 
flash  slowly  indicating  entering
into  learning  mode.  Learning  will 
be  completed  within  25
seconds.  Afterwards,  the  LED  and 
load  will  keep  on  5sec  or  LED
flashes  quickly  for  5sec  and  load  is 
off  to  confirm  successful
learning  (See  FIG.15-C).
After  learning  procedure,  the 
detector  returns  to  AUTO  mode
with  LED  and  load  being  off.
Learning procedure:
NOTE
Only  Lux1  has  Lux  learning  function.
When  the  actual  light  level  is  out  of  the  range  10  -  2000Lux,
detector  will  learn  25sec,  then  the  red  LED  flashes  quickly  for
5sec.  When  the  actual  light  level  is  below  10Lux,  Lux  value  is  set
to  10Lux,  or  is  above  2000Lux,  Lux  value  is  set  to  2000Lux.
Installer  should  be  away  from  the  detector  to  avoid  affecting  the
luminous  flux  that  reaches  the  detector  when  learning  Lux  value.
LED  flashes  slowly  for  25sec
&  Load  is  off
W
FIG.15-C
W
LED  and  load  off
LED  flashes  quickly  for  5sec  &
Load  is  off  (the  actual  light
level  range  is  out  of  10  - 
2000Lux)
Detector  switches  to  AUTO  mode
W
W
FIG.15-A
Adjust  knob  to
“  ”  from
other  position
FIG.15-B
1sec  after,  goes
back  to  ”  “
LED  and  load  keep  on  5sec 
(the  actual  light  level  range
is  10  -  2000Lux)
•
•
•
•
•
•
•
Adjust  knob  to  other 
position  from  ”  “ 
2000
100
10
300
2000
100
10
300
2000
100
10
300
2000
100
10
300
2000
100
10
300
www.grupotemper.com 
KDP-DALI-02
Presence detector for DALI lighting control
Instructions  manual  |  46