28
kobalttools.com
CARE AND MAINTENANCE
2
J
3
2
1
L
L
M
J
2
3
1
L
M
5. Using cleaning brush (Q), thoroughly brush suction tube
(B), inlet screen (I), and prime tube (C) until all heavy
paint or stain residue is removed.
6. After components have dried, insert the single seal tip
into the spray guard housing with the metal end facing
down. Using the pointed eject end of the spray tip, press
against the rubber opening of the single seal tip until it fits
perfectly into the housing, as shown in Figure 3.
7. Insert the spray tip (L) into the opening of the spray gun
housing, making sure the orifice is facing forward.
8. Screw the spray guard (J) to the spray gun housing by
turning counterclockwise. Tighten by hand until the single
seal tip (M) is secure.
9. Re-insert clean internal gun filter (E) into spray gun
handle.
10. Tighten safety screw at base of handle housing using
hex key (R).
11. Set prime spray valve switch (H) to prime/clean position.
12. Place prime tube (C) into waste pail.
13. Turn power switch on and allow water to flow though
spray system until water coming out of prime tube (C)
is clear.
Note: It may take several gallons of water depending on
the type of paint used. Continue to refill clean water
bucket as needed.
14. Set the prime spray valve switch (H) to the spray position
and unlock safety lock on squeeze trigger.
15. While placing spray gun over waste pail, depress trigger
and turn power switch on.
16. While spraying, shake the spray gun to loosen any paint
that may be trapped inside.
17. With the arrow on the spray tip facing forward, continue
spraying for 10-15 seconds. Stop spraying and rotate
the spray tip so the arrow is facing the operator, as
shown in Figure 4. Spray again for 10-15 seconds.
Repeat this several times until the single seal tip is
completely cleared.
L
4
