OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
An in-line oiler is not provided however recommended to be installed to the air supply
line to increases tool life and keeps the tool in sustained operation. The in-line oiler
should be regularly checked and filled with air-tool oil. Proper adjustment of the
in-line oiler is performed by placing a sheet of paper next to the tool’s exhaust ports
and holding the throttle open approximately 30 seconds. The in-line oiler is properly
set when a light stain of oil collects on the paper. Excessive amounts of oil should be
avoided.
In the event that it becomes necessary to store the tool for an extended period of
time, it should receive a generous amount of lubrication before storing the item. The
tool should be run for approximately 30 seconds to ensure oil has been evenly
Recommended lubricants: For proper care and
maintenance use 3 drops of air tool oil, or any other
Clean the tool all over with a cotton rag after each use.
high-grade turbine oil containing moisture absorbent,
rust inhibitors, metal wetting agents and an EP (extreme
pressure) additive (not included). (See Figure 1)
distributed throughout the tool. The tool should be stored in a clean and dry
environment.
12
1
Storing
Impact Wrench must be well cleaned and lightly lubricated
Store Impact Wrench in a dry and safe place out of reach of children
NOTE
This tool features a weep hole (part F) on
the front protective cover. The weep hole (part F)
allows excess air to be released from the impact
wrench automatically while still lubricating the
tool when the proper lubrication instructions are
followed. (See figure 4)
