4
ELECTRICAL SAFETY
WARNING: To reduce the risk of electrocution, keep all connections dry and off the
ground. Do not touch plug with wet hands.
•
VOLTAGE:
Before plugging in the tool, make sure that the outlet voltage is within the voltage marked
on the tool’s data plate.
•
DO NOT USE “AC ONLY” RATED TOOLS WITH A DC POWER SUPPLY.
•
DO NOT EXPOSE POWER TOOLS TO RAIN OR WET CONDITIONS.
Water entering a power tool
will increase the risk of electric shock.
• If operating the power tool in damp locations is unavoidable, always use a Ground Fault Circuit
Interrupter to supply power to your tool. Always wear electrician’s rubber gloves and footwear in
damp conditions.
•
DO NOT ABUSE THE CORD.
Never use the cord to carry the tools or to pull the plug from the
outlet. Keep the cord away from heat, oil, sharp edges,
or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of electric shock.
•
USE THE PROPER EXTENSION CORD.
Extension Cords
Use only extension cords that are intended for out door use. These extension cords are identified by a
marking: “Acceptable for use with outdoor appliances, store indoors while not in use.”
Use only extension cords having an electrical rating equal to or greater than the rating of the product.
Do not use damaged extension cords. Examine the extension cord before using, and replace it if it is
damaged. Do not abuse extension cords, and do not yank on any cord to dis connect it. Keep the cord
away from heat and sharp edges. Always disconnect the extension cord from the receptacle before
disconnecting the product from the extension cord.
• Make sure that your extension cord is in good condition.
• When using an extension cord, be sure to use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and
overheating.
• Table 1 shows the correct size to use, depending on cord length and ampere rating. If in doubt, use
the next heavier gauge: the smaller the gauge number, the heavier the cord.
• When operating a power tool outdoors, ALWAYS use an outdoor extension cord marked “W-A” or
“W.” These cords are rated for outdoor use and reduce the risk of electric shock.
• Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles that
accept the tool’s plug.
Ampere
rating
Volts
Total Length of Cord in Feet
120 V~
25ft.
50ft.
100ft.
150ft.
A. W. G.
0~6
18
16
16
14
6~10
18
16
14
12
10~12
16
16
14
12
12~16
14
12
not recommended
Table 1
