14
OPERATION INSTRUCTIONS
NOTE:
Before attempting to use this tile saw, familiarize
yourself with all its operating features and safety
requirements.
FILLING THE WATER TRAY
1. Disengage the angle table lock as shown (Fig. 6).
2. Lift and remove the angle table.
3. Check that the water plug is correctly positioned.
4. Fill water to the minimum level.
CAUTION:
Fill water to the minimum level of the
reservoir before cutting. Check the water level every 1/2
hour during use and refill if needed.
PARALLEL RIP FENCE ADJUSTMENT
Fit the parallel rip fence to the top of table, securing it to
both sides.
Adjust the position and tighten the parallel rip fence
locking knob securely.
STARTING AND STOPPING
1. Connect the unit to a power source with the correct
voltage and frequency (120V, 60Hz).
2. To start the machine, lift the switch knob to the “UP”
position (Fig. 7).
3. To stop the machine, depress the switch knob to the
“DOWN” position (Fig. 7).
4. To lock the switch in the “OFF” position, remove the red
safety key. This safety feature prevents children and
others from accidentally starting the machine.
USING THE LASER/LED
1. When the Laser/LED switch is in the center position,
neither the laser nor the LED can be turned on. Move
the switch backward to power the LED light, or forward
to power the laser. Always turn off the laser light when
you are finished cutting (Fig. 8).
2. Align the laser beam with the line-of-cut by adjusting
one or both adjustment knobs on the sides of blade
guard.
8
7
Safety key
6
