KoamTac KDC200 KDC250, Руководство по программированию

Страница: 2 / 24

KDC200 Programming Manual
Copyright, License and Warning page
Copyright
©
2007, 2008 by KoamTac, Inc. All rights reserved
No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means,
without permission in writing from KoamTac.
The material in this manual is subject to change without notices.
KoamTac reserves the right to make changes to any product to improve reliability, function, or design.
KoamTac doesn’t assume any product liability arising out of, or in connection with, the application or use of
any product, circuit, or application described herein.
Follow all warnings and instructions marked on manual and units
Use only the power source specified in this manual or marked on the units
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO ANY TYPE OF MOISTURE
DO NOT LOOK DIRECTLY INTO LASER or point the laser into another person’s eyes. Exposure to the beam MAY CAUSE EYE
DAMAGE.
Caution RF EXPOSURE INFORMATION.
A minimum separation distance of 7.9 inches (20cm) must be maintained between the user and the external
antenna of repeater to satisfy FCC RF exposure requirements. For more information about RF exposure, please
visit the FCC
CAUTION
Changes or modifications not expressly approved by the manufacturer responsible for compliance could void
the user’s authority to operate the equipment
WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
INFORMATION TO USER:
This equipment has been tested and found to comply with the limit of a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation; if this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient / Relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit difference from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help
CAUTION
RISK OF EXPLOSIN IF BATTERY IS REPLACED AN INCORRECT TYPE.
DSPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS