V1.0 / 20.03.2015 2 / 5
CHROMOFLEX
®
Pro
KNX DIN-Rail ECO
Installation
Fig.1
Dimensions:
Fig. 2
6. Connection
Please note that the LEDs have to be connected in a de-energised state of the dimmer!
Notes on the selection of the power supply:
Important: The power supply must have appropriate pulse load. Unstabilized or too weak power supplies may lead
to unwanted flickering effects in the color changes.
Important: The module must be operated with a power supply, that is suitable for the used LEDs! Improper power
supplies may lead to malfunctions, unwanted flickering effects, destruction of LEDs, destruction of electronics or in
worst case to overheating. We strongly recommend using high-quality (stabilized) switching power supplies!
We strongly advise against the use of unstabilized cheap power supplies! Also special "LED" power supplies are
usually unsuitable as they may already contain control electronics for constant current, which may not be compatible
with control devices as the
CHROMOFLEX
®
Pro
.
We always recommend switching power supplies in power supply technology! Suitable power supplies are available
from us.
One power supply can be used for several units in parallel, if the maximum output power of the supply is observed.
For wiring cables with a cross section of max. 2.5mm² can be used.
This product is designed for an installation
on a DIN rail. At first you have to press the
black peg down (1). Second, place the
backside of the device in the upper corner
behind the upper hook (2). Now press the
device over the whole DIN rail (3, 4). At
last, push the peg back into the upper
position (5).
