KNOVA KN RO-1321, Руководство пользователя

Страница: 10 / 28

OPERATION INSTRUCTIONS
CHIP SHIELDS
Always wear eye protection. The chip
shields are not intended as salety guards.
WARNING
Always turn the router motor off and
unplug the router lrom its power source before making
any adjustments or installing accessories. Failure to
turn the router motor off and unplug the router could
result in accidental starting, which can cause serious
personal injury.
WARNING
To remove the chip shield from the base, press inward on the
tabs until the chip shield releases from the base and remove
the chip shield. To attach, place chip shield in position, and flex
sides while pushing it in until it snaps back into place.
The chip shield deflectors help keep dust
and chips away from the operator; they will not stop
objects larger than woodchips thrown from the bit.
CAUTION: Always have the chip shield deflector in
place on the base when operating the router.
WARNING
DUST EXTRACTlON HOOD
To attach the hood onto the base, align the two tabs on the
hood with the two slots on the port, located on the back of
the base, and secure it by turning it clockwise.
Always turn the router motor off and unplug
the router from the power source before making any
adjustments or installing accessories. Failure to turn
router motor off and unplug the router could result in
accidental starting, which can cause serious personal
injury.
WARNING
MAINTENANCE
To ensure safety and reliability, all repairs
should be performed by a qualified service technician at
an qualified Service Center.
For your safety, Always tum off the switch
and unplug the router motor from the power source
before performing any maintenance or cleaning.
WARNING
WARNING
GENERAL
Only the parts shown on the parts list are intended for repair or
replacement by the customer. AII other parts represent an
important part of the double-insulation system and should be
serviced only by a qualified service center technician.
It has been found that electric tools are subject to accelerated
wear and possible premature failure when they are used to
work on tiberglass boats and sports cars, wallboard, spackling
compounds or plaster. The chips and grindings from these
materials are highly abrasive to electrical tool parts.
Consequently, it is not recommended that this tool be used for
extended work on any fiberglass material, wallboard, spackling
compound, or plaster. During any use on these materials, it is
extremely important that the tool is cleaned frequently by
blowing with an air jet.
Always wear safety goggles or safety
glasses with side shields during power tool operations,
or when blowing dust. If operation is dusty, also wear a
dust mask.
WARNING
ROUTINE MAINTENANCE
Do not at any time allow brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic, which may result
in serious personal injury.
WARNING
• When work has been completed, clean the tool to allow
smooth functioning of the tool over time.
• Use clean, damp cloths to wipe the tool. Check the state
of all electrical cables.
• Keep the router-motor air openings free from oi!, grease,
and sawdust or woodchips, and store the tool in a dry place.
• Be certain that all moving parts are welllubricated,
particularly after lengthy exposure to damp and/or dirty
conditions.
• For collet/nut care, see the Operation section of this
manual.