OPERATION INSTRUCTIONS
7
As your trailing hand passes over the cutter head remove your
leading hand and place behind your trailing hand and repeat
until the entire length of work piece has been cut.
Feed with the grain whenever possible, if the nature of the
work piece is such that it must be feed against the grain take
very light cuts and feed slowly. When using long work pieces
use extra supports at both end of the planer.
With the grain
Against the grain
Rotation
Rotation
FEED
FEED
For your safety, use the push block and push stick to hold
and feed workpiece when jointing wood that is narrower than
75mm (3”), planing wood thinner than 75mm (3”).
Push block
Push stick
BEVELING AND DHAMFERING
• The fence on the jointer/planer is adjustable from
0° to 45°. Adjust the fence to the desired angle
and tighten fence tilting handle
• Beveling refers to cutting the entire edge of a board at
an angle. Beveling may require several passes due to
the depth of cut needed.
• Chamfering refers to removing only the corner of
the edge of a board. Normally a chamfer is made
on one pass.
Chamfer edge
Bevel edge
USING AVACUME HOSE
A standard dust collection hose can be attached to the
exhaust port (2-1/2” Dia.) underneath the outfeed table.
Jointer will perform properly at all depths of cuts up
to 1/8” when used with a dust collecting system.
To attach a dust collecting system:
• Insert the dust collection hose to the exhaust port on
the rear of the jointer.
• Turn the dust collecting system on.
• Turn the jointer on.
• Periodically replace/empty bag in dust collecting system.
Содержание KN CM-11MA
